(NanoRealm) - Berkeley Lab researchers have found a better way to trap light in photovoltaic cells through the use of vertical arrays of silicon nanowires. This could substantially cut the costs of solar electric power by reducing the quantity and quality of silicon needed for efficient solar panels.

Solar cells made from silicon are projected to be a prominent factor in future renewable green energy equations, but so far the promise has far exceeded the reality. While there are now silicon photovoltaics that can convert sunlight into electricity at impressive 20 percent efficiencies, the cost of this solar power is prohibitive for large-scale use. Researchers with the Lawrence Berkeley National Laboratory (Berkeley Lab), however, are developing a new approach that could substantially reduce these costs. The key to their success is a better way of trapping sunlight.



“Through the fabrication of thin films from ordered arrays of vertical silicon nanowires we’ve been able to increase the light-trapping in our solar cells by a factor of 73,” says chemist Peidong Yang, who led this research. “Since the fabrication technique behind this extraordinary light-trapping enhancement is a relatively simple and scalable aqueous chemistry process, we believe our approach represents an economically viable path toward high-efficiency, low-cost thin-film solar cells.”

Yang holds joint appointments with Berkeley Lab’s Materials Sciences Division, and the University of California Berkeley’s Chemistry Department. He is a leading authority on semiconductor nanowires - one-dimensional strips of materials whose width measures only one-thousandth that of a human hair but whose length may stretch several microns.

“Typical solar cells are made from very expensive ultrapure single crystal silicon wafers that require about 100 micrometers of thickness to absorb most of the solar light, whereas our radial geometry enables us to effectively trap light with nanowire arrays fabricated from silicon films that are only about eight micrometers thick,” he says. “Furthermore, our approach should in principle allow us to use metallurgical grade or “dirty” silicon rather than the ultrapure silicon crystals now required, which should cut costs even further.”

Yang has described this research in a paper published in the journal Nano Letters, which he co-authored with Erik Garnett, a chemist who was then a member of Yang’s research group. The paper is titled “Light Trapping in Silicon Nanowire Solar Cells.”

Generating Electricity from Sunlight

At the heart of all solar cells are two separate layers of material, one with an abundance of electrons that functions as a negative pole, and one with an abundance of electron holes (positively-charged energy spaces) that functions as a positive pole. When photons from the sun are absorbed, their energy is used to create electron-hole pairs, which are then separated at the interface between the two layers and collected as electricity.



Because of its superior photo-electronic properties, silicon remains the photovoltaic semiconductor of choice but rising demand has inflated the price of the raw material.

Furthermore, because of the high-level of crystal purification required, even the fabrication of the simplest silicon-based solar cell is a complex, energy-intensive and costly process.

Yang and his group are able to reduce both the quantity and the quality requirements for silicon by using vertical arrays of nanostructured radial p-n junctions rather than conventional planar p-n junctions. In a radial p-n junction, a layer of n-type silicon forms a shell around a p-type silicon nanowire core. As a result, photo-excited electrons and holes travel much shorter distances to electrodes, eliminating a charge-carrier bottleneck that often arises in a typical silicon solar cell. The radial geometry array also, as photocurrent and optical transmission measurements by Yang and Garrett revealed, greatly improves light trapping.

“Since each individual nanowire in the array has a p-n junction, each acts as an individual solar cell,” Yang says. “By adjusting the length of the nanowires in our arrays, we can increase their light-trapping path length.”

While the conversion efficiency of these solar nanowires was only about five to six percent, Yang says this efficiency was achieved with little effort put into surface passivation, antireflection, and other efficiency-increasing modifications.

“With further improvements, most importantly in surface passivation, we think it is possible to push the efficiency to above 10 percent,” Yang says.

Combining a 10 percent or better conversion efficiency with the greatly reduced quantities of starting silicon material and the ability to use metallurgical grade silicon, should make the use of silicon nanowires an attractive candidate for large-scale development.

As an added plus Yang says, “Our technique can be used in existing solar panel manufacturing processes.”

---

Provided by: Provided by Lawrence Berkeley National Laboratory (http://www.lbl.gov/)
Source: http://www.physorg.com/news186850199.html